Has anyone found a compact lifter that can slip between 120 mm glass fins without scuffing but still handle around 180 kg units with a proper safety margin? On a lobby mock-up last week, our 8" pads and yoke geometry kept kissing the silicone sightline, which kills the clean reveal I’m designing for. Looking for models (dual-circuit preferred) or rigging tweaks that balance crisp aesthetics with real-world load and tilt control.
We ran into the same with 120 mm fins and fixed it by flipping the pad arms to an in‑line 1x4 on a dual‑circuit Wood’s Powr‑Grip frame, then coming in at a 10–15° skew so the yoke clears and the cups land just outside the “silicone sightline” your 8" pads were kissing. It carried about 180 kg with margin using the short‑stem mounts, but the smaller footprint needs spotless glass to hold; is your 120 mm truly clear between fins?
Quick fix that’s worked for me: switch the frame to 6" low‑profile cups with stub arms and add a 75–100 mm bail offset with a rated shackle so the head clears the fins and stays off the silicone sightline; four 6" cups still covered about 180 kg for us, but check the capacity chart for your “proper safety margin.” If you need a touch more WLL, bolt on a short in‑line bar for two extra 6" cups — Powr‑Grip has the quick‑change hubs here: https://www.powr-grip.com.